AI Assistant
Activity
 
Notifications
Clear all
bill93
bill93
@bill93
Member P&R, Founder
Joined: July 1, 2010 9:00 pm
Last seen: September 17, 2026 6:42 am
Topics: 291 / Replies: 9708
Reply
RE: Least Squares Adjustment for Level Runs

Mathematically its a loop regardless of the direction or order the legs are run. John Hamilton and Chris Mills in their work may consider subtle effe...

6 years ago
Reply
RE: Base Rover Newbie

And he says, "sure, but while you're here could you do me a favor and find the corner pin that I know is over there somewhere?"

6 years ago
Reply
RE: Least Squares Adjustment for Level Runs

A 1-way run between two good benchmarks is a better check than a loop on one, because, as well as checking your work, it can indicate whether one of t...

6 years ago
Reply
RE: Base Rover Newbie

I am not an expert, so feel free to ignore .... If all that matters is relative positioning in your project, then you could just use a quick position...

6 years ago
Reply
RE: Missouri Test

His previous 7 are listed in his profile, and the answer is No. ?ÿ

6 years ago
Reply
RE: Terris Novalis sculptures in Consett, County Durham

www.atlasobscura.com/places/terris-novalis Built on the site of the oldest commercial railway line in Britainƒ??the Stanhope and Tyne Railway Lineƒ??...

6 years ago
Reply
RE: Is this "Land Surveying" in your State?

If you read their entire site, it does fairly describe the situation and include appropriate cautions, but that info is somewhat buried. A customer co...

6 years ago
Reply
RE: Is this "Land Surveying" in your State?

The service should probably be allowed, but only with appropriate disclaimer that it does not represent official surveys, and with reasonable claims f...

6 years ago
Reply
RE: Judge to decide fate of man who saws neighbor's garage in half

I'm puzzled why two surveyors disagreed by multiple feet. Was the deed that split the properties in the past that ambiguous? And it irritates me that...

6 years ago
Reply
RE: Hysteresis of Wild GDF22 tribrach?

Hysteresis is getting a different result when approaching a measurement from opposite directions. In this case it is mostly due to a small mechanical...

6 years ago
Page 141 / 500