One thing I wish was different on Topcon magnet, is the ability to export point number ranges. Maybe there is a way though and I just haven’t found it...

@beuckie @rover83 I'm not confident we could completely eliminate the use of the Topcon GLS with a Riegl yet, maybe we can, it is very fast, but we'l...

@beuckie I'll get to try a vz600i in a few months, 30 seconds per scan I'm told. It is a beast but imho a vz400i is more rugged for outdoors. You c...

You just need to buy a Riegl Vz400i or vz600i and all these problems are solved at once. No targets, straight scanning without problems.

@lukenz In short I'll just need a cheap robot (or two) in the future. Many Topcon robots are really inexpensive compared to Trimble/Leica stuff. ...

I run Topcon and Sokkia gear and wouldn't replace it for any Leica or Trimble. You pay in excess for maintenance and other crap. If you buy a Topcon ...

The work is done according to the ASCE Standard "CI/ASCE 38-02, Standard Guideline for the Collection and Depiction of Existing Subsurface Utility Dat...

Here's another video, this one by a landscape contractor.?ÿ He first uses Moasure to measure the perimeter of a proposed raised area, and you can see ...

If in fact the GMP111-0 uses the same prism, then you would specify the 17.5 mm prism constant and add a 20 mm distance offset to the measurement.?ÿ T...

Unless you are going to put plaster on it it is not lath. I really don't know who caused the proliferation of this term used by surveyors to describe ...

@norman-oklahoma doesn't this break when poundign them into the ground? So if lath is used, no stakes are used for the actual point? ?ÿ

What are the dimensions of lath and the wood used? Over here no one speaks about lath. We just say a stake for everything.

i have a Sokkia Sdl30. Standards rods (fiberglass). Works good but onboard sofwtare sucks. You'll need a connection to Magnet Field to use it with eas...