that slider looks good.
Will do. I am procrasting this as I just bought some other equipment, but I will report back if I buy it.?ÿ
The sliding pole has a diameter of 0.05'. ?ÿ
Thanks all for the messages.?ÿ Steve, I will check on the ball adapter order.?ÿ Lee: I will measure the slide pole and follow-up. As far as prism on t...
Posted by: leegreen It is a combination of the Seco 6000 with a RAM Ball mount to standard 1 1/4" prism pole. I have 3d printed plastic adapters to ma...
Posted by: leegreen I use this setup ?ÿ Hello, LeeGreen Where can I get a monopod like that? The only one that I see is for use with the seco 6000 min...
Well, that's one more positive response about this AdirPro prism. I guess I should take a chance. Those $150 dollar ones on ebay with the "make offer"...
Posted by: Ben Davidson For rust, I would just rub a little remington oil on them where you are seeing the problem. I wouldn't think a little rust wou...
I think bipods are a must. Especially, with robotics. I had suspect closures until I started using them. I realized I wasn't as steady as I used to be...
Hey S1084h, I really appreciate the info. That makes me feel even better about it. I will probably buy it for sure now based on that.?ÿ I like that I ...
Thanks for the reply.?ÿ I may take a chance on the AdirPro prism, afterall.?ÿ
Thanks for the reply.?ÿ I may take a chance on the AdirPro prism, afterall.?ÿ
Is it just me, or does 1:20,000, 1:30,000, and 1:50,000 sound like good closures? I have topcon gpt8205 that I have gotten over 1:50,000 with, but I a...
Congrats! It's a good feeling to have!?ÿ
I am with MightyMoe, maybe that is why they did it. However, still not a reason to do so. If you find it and it checks, hold it and go on. I saw a reb...
Great replies and I appreciate the feedback. I agree that the smi software is great and I prefer it over the more menu driven software. Version 7 on ...
Thanks for the reply. I am wanting used, but with no experience using any of these as compared to the 48, I am hoping for more feedback on the increas...
