We use the tangents to fit the curves as best we can. Even with locating the rail every 5 feet with the trolley. Another thing to be aware of is the i...

Civil 3D 2013 w/ Sincpac-C3D v3.5.5161Raster Design 2013TBCTBC-HCETrimble GEDO Office 2

Not that day, but after the week I've had I probably should have!

For my portion of the work, the office part is far less than the field. That day the field time was between 4 and 5 hours. The downloading, processin...

Leica Cyclone is the one that I've always used and the one that other companies I've worked for used as well.

They tried using the same stuff, but liked this method better and it's what the crews were used to.

A company I used to work at had their crews use a range pole or a 25 foot level rod to measure manhole inverts. They would use similar triangles to ge...

Draw is the AutoCAD pulldown menu that Polyline is on. So Draw is not the command, but the menu where the command is found.

I worked out a Suburban for about a year. Accessing things from the back seat isn't as easy as it may seem, but that all depends on the way you build ...

Maybe not the "field"They do steel service and fabrication. The track is a side track off of one of our lines. They want to be able to receive and sen...

Maybe not the "field"True, maybe it should have said "Pics from inside". What thing are you referring to?

Could you also send me a copy of it too? Email in profile is good. Thank you very much.

2 foot +/- was the interval I used. Which produced 7,162 locations in approximately 14,380 feet. But if you wanted both rails and centerline, it's 21,...

It was 2 foot. The engineer wanted 1 foot :-/

Not yet. This is mostly for some preliminary mapping to identify some trouble spots. For areas that will be reconstructed/repaired, I'll go back throu...

Yes, that is correct, and the super elevation and gauge.

Continuous for most of it. The Google image only shows some of the shots. I measured the rail at an approximate 2' interval for almost 2.5 miles. I on...