Notifications
Clear all
Strictly Surveying
3
Posts
3
Users
0
Reactions
3
Views
Topic starter
We are having issues with getting our SNB900 repeater operational with our GCS900 machine controls and our SCS900/985L rover. We are up to date on the firmware and the SNB900 is set to the correct channel. I don't believe there are any additional settings that would cause an issue. Any ideas out there or experience?ÿwith a similar setup?
Many thanks for any advice you can offer.
Posted : 15/08/2018 3:23 pm
Dont remember the specifics but I think there is a setting where it can be set to repeat from a base or from another repeater.
Posted : 16/08/2018 11:27 am
Make sure it is set to easy ip and repeater source or repeater source 1.
Posted : 17/08/2018 4:49 am
