@lukenz Had a few times exactly the same problem with leica Trcp1200+ and since the Geomax is in fact a Leica I think the problem is the same. My solu...
The cheapest solution I did when I had my tcrp1103 was to buy a dead geb70 or geb141 for almost nothing and go to a batteryshop nearby who replaces eb...
That is indeed probably the problem. Output format can be the same but you have to connect the dc with the antenna. Survey brands are very ?ÿprotectiv...
Leica gs18t is for the moment the only gnss antenna where the tilt function doesn??t need the tilt calibration. I do not use this on my galaxy g1 plu...
Best to test before buying.... Don??t think this will work
Running a G1 or G6 on Trimble software will not work i guess. But survCE will work on Trimble TSC3 dc?/p> So you can run survCE on a Trimble datacoll...
Think you have to work with second window/code as attributes for beg end curve.... I just turned predefined off on my cs15. You have a full keybord......
With my g1 plus i have with Gps/Glo/Gal/Bei in Belgium in open sky On average a 30 sats in sight and on the vrs network flepos i get mostly the typica...
I??m Using a South Galaxy G1 plus 336 ch in Belgium as a rover on rtk vrs 4 constallation. It uses a trimble bd990 board. Software is survce (gnss on...
Working for over a year with a South G1 plus (336 ch BD 990 trimble board). Great results on vrs rtk flepos 4 constellation in Belgium. I run survCE...
Are you working on a cs20 controller with leica captivate Software ?ÿ page 37 and on
Hello, It's a TCR 1103... Could be EDM Board fail.
The relase notes from leica smartworx v9.01: Support of RH17 and TCPS30: Additional Long Range Bluetooth device RH17 and TCPS30, which will bereleased...
