Notifications
Clear all
shelby-h-griggs-pls
@shelby-h-griggs-pls
Registered
Noble Member
Joined: Jul 8, 2010
Topics: 67 / Replies: 841
Reply
RE: Used Equipment Dealer?

Canada, not US based, but they ship to US and while I have only purchased once, it was a good experience. SHG

2 years ago
Forum
Reply
RE: 400' AGL

@pkm04558 yep, but not all UAV's are set up as nice as the Wingtra, definitely a nice platform and actually some thought into mapping by the engineers...

2 years ago
Reply
RE: 400' AGL

@flga-2-2 true, but that seems impractical for every flight. I understand the 400' AGL and it is a good rule since other than take off landing cycles,...

2 years ago
Reply
RE: 400' AGL

Based on the FAA exact response; "The 400 ft AGL operating limitation is based on the altitude beneath the drone at any time", I think it is obvious i...

2 years ago
Reply
RE: Shelby Griggs

@james-fleming FYI, we have been known to travel 🙂 One plane is in California this week. Last year we did acquestion in MI, CO and UT and a couple we...

2 years ago
Reply
RE: 400' AGL

This is all theoretical, no specific project in mind, but do see where it could be an issue and why I asked the FAA. Bottom line is the pilot must nev...

2 years ago
Reply
RE: 400' AGL

Well yes that would be best, then you could make sure to not bust the 400' AGL. I suspect most either don't worry about it, or fly considerably under...

2 years ago
Topic
2 years ago
Replies: 11
Views: 2
Reply
RE: Shelby Griggs

James thanks for reaching out. Just to close the loop for future readers, we made contact off line. SHG

2 years ago
Reply
RE: Matrice 300 RTK with Zenmuse H20

I know this is a old thread, but Isn't the Wingtra in same general price as a M300? I know with the L1 the M300 is between $30-40K all in. The wingtra...

2 years ago
Reply
RE: Stock Market

Certainly not time to sell if you bought when it was up 20%, at this point unless it goes to zero you haven't lost that money yet 🙂 Time to sell was...

2 years ago
Reply
RE: Leica RCS1100 Parts

I have now inherited another mostly complete RCS setup, the controller on that 2nd set is dead, but between the two sets I have all bits and parts to ...

2 years ago
Forum
Topic
2 years ago
Replies: 4
Views: 0
Reply
RE: Leica GS18i Rover with Camera

Gene, I have one with about a year of experience but haven't used the imaging too much, only to get coordinates on some aerial control that was in tra...

3 years ago
Reply
RE: Data gap

@bill93 doubt it is a cable as it seems to be happening on both base and rover at same time, some sort of RFI in the area could be affecting both base...

3 years ago
Page 2 / 61
Share: