Got it!!!Ran bench with robot through my control points.Horiz over the entire site difference between grid and ground .04' so i left it on grid.Edit t...
LDD 2002 can be installed but it's not easy and it can easily be broken. I've got one client that refuses to listen to me onhow not to break it. But t...
I use C3D and using description keys that use point styles and Label Styles it does exactly what you are asking.If you are interested I can explain in...
So here is what I did.... RTK Base and Rover, Automonus Position, Geoid12aLocated all site control, moved to a site control point, adjust to a bm,chec...
MightyMoe, post: 333439, member: 700 wrote: I'm not surprised you are seeing 0.05', that can be the "error" in the model, they aren't perfect. I would...
Civil 3d?If so......Use Sheet Manager. Last time I used it I did all the viewports for a 50 page plan in about 30 min.Granted there was a lot of draf...
I don't use anymore because I have no need. But this kit Use the black u shaped adapter with a plumb bob the front is -.11 ant back is 0 offset works...
I had a plat where I had to match another surveyors R/W plan that ended up in a line segment of 0.05'. I hated doing it but itwas either that or call ...
Just to add another solution :)I use PDF-Xchange by tracker software.It's a freebie that works great.You can easily zoom in and out by holding the ctr...
Or use a 8" Windows Tablet.It's incredible and it only cost $200.
It's great in full sunlight.At least the Dell Venue 8 Pro is.We tried a Win Book 8 and the screen just didn't have the brightness to handle it.I can t...
My Son worked there for 3 years. Is good friends with manager and lots of employees :)They have a floor model printing all the time. Helps sell them. ...
You need to look at the port and see what USB Port it is using for the driver.Have you tried removing all references to the printer, reboot, plug it b...
I took it to my dealer and It was worse than when I took it in when I got it back.I took it back made him reset it and it was still off.Got out the ma...
