@just-a-surveyor?ÿ I just gave the cliff notes version yesterday the rest of the story is further up the thread.?ÿ Long story short, somewhere around ...

Reviving an old topic here, but I finally got my HP Designjet 800 to print direct from AutoCAD 2018 in Win10-64bit.?ÿ Basically I deleted and reinstal...

?ÿ The pendulum mounted prism in an automatic level actually changes the line of sight to compensate for any un-levelness of the instrument.?ÿ If the ...

"Our new line of robotic total stations only works if you have a Trimbeica survey rig key within 1,500' of the instrument"?ÿ It's part of the new and ...

The planning commission treats the GIS as the gospel.?ÿ Had a case a few years back where my boss had created a subdivision with a couple of commercia...

I recently found that Seco makes a prism assembly that looks very similar to the Nikon above (Seco 6400-10).?ÿ It can have an offset of 0mm, -30mm, or...

Locally we often use a print out of the GIS to apply for rezoning of parcels. Nine times out of ten once the rezoning is approved and shows up on the ...

I don't have numbers on the 5600, but the S7 specs say it can Autolock at 1640-2297 ft to passive prisms and 2625 ft to the MT-1000 in active track mo...

Pop in a Win7Pro disk, boot from the Win7Pro disk, format hard drive, install Win7Pro ?ÿ

According to the manual I downloaded from Topcon, holding down the on/off button for 10+ seconds will cold boot the FC-2600.?ÿ If that doesn't cause t...

There should be a manual just for the FC-2600.?ÿ If you don't have one, visit Topcon Support and download one.?ÿ Figure out how to do a Hard Reset.?ÿ

I don't remember the procedure, but figure out how to do a hard reset (maybe hold down the power key for 10+ sec).?ÿ If it's like the FC-2500, the OS ...

Inverse with Area under the Area/Layout will do what you want.?ÿ I run the boundary by the calls on my survey, polyline the pieces, then run Inverse b...

Jealous......I need to get back in the air. ?ÿ

@chris-mills?ÿ The funny thing is that the missing word appears in the preview of the thread but is replaced if you open the thread.

It hurts my feelings when I occasionally drop a box tape down a manhole or catchbasin.?ÿ One small goof and that drone is going to careen off the wall...

When posts get nuked there should be a place holder where the offending post used to be just for continuity.?ÿ I suggest either a?ÿ chalk outline of t...

They're pretty tough.?ÿ I was removing mine to get a shot on a pin under a bush and fumbled it.?ÿ Murphy's law came into play........it first hit the ...

Hard to protect people from themselves.?ÿ When marking lot corners for construction I put 3' stakes on the actual lot corners and 18" stakes on PCs, P...

I don't have it in front of me, but I believe it's Review or Edit Raw Data under the Job tab. ?ÿ