Sorry, to be clear you don't need to "convert" your setting-out co-ordinates, just use them as ground co-ordinates so they tie up with the length of t...
In the absence of evidence to the contrary it would be fair to assume that everyone from the design engineer to the steel fabricator will not account ...
Sounds like Lee has the answer for Magnet field. Offsets to two lines at once. You can always stake the line, drive stake, make offsets then then esca...
1200+ Series can be controlled by CS20 at least. You'll need the right version of the firmware to suit Captivate version 1 2 or 3. Register the both i...
Posted by: lukenz Posted by: squowse Posted by: lukenz Posted by: squowse On our forum in the UK i was introduced to the?ÿEmlid Reach RS+ Seems to be ...
Posted by: Richard Jim the difference there for me would be I'm looking down to a recorder on a pole and through the close up part of multifocals. To ...
Posted by: lukenz Posted by: squowse On our forum in the UK i was introduced to the?ÿEmlid Reach RS+ Seems to be exceptional value but maybe won't giv...
On our forum in the UK i was introduced to the?ÿEmlid Reach RS+ Seems to be exceptional value but maybe won't give the GNSS details you're looking for...
Trimble Access has a nice circular object routine. 2 grazing sights and then it turns and measures one reflectorless distamce to the centre. The radiu...
Thanks for confirming that. I'm on the look out for a Captiavte compatible GNSS receiver if anyone is selling one. Either with or without CS10/15. (CS...
Maybe the imaging doesn't work correctly? There are one or two limitations compared to the newer instruments.
Posted by: Dave Lindell Obvert is a verb. I've always called the inside top the soffit, the flow line the invert, and the horizontal line through the ...
Posted by: Norman Oklahoma Once had an engineer, a PE of near retirement age, insist that the invert of a pipe referred to the top. The OBvert is the ...
I think the older Nikon one (eg NPL-332) worked on a different technology (time-of flight?) that would only get a reading from a focused object. Leica...
Wasting you time trying to use GPS under tree cover for a topo. Use a total station. RTK is Real time Kinematic. The solution is available in real tim...
Does your occupied point 1 have an elevation? It would need one. ?ÿ
I would probably use -"station elevation" setup method fornthis task. Or even just survey basic, the vertical distance is displayed. I think the tickb...
I think there is a "2d survey" tick box somewhere. From memory I had this ticked by accident and no elevations on any measured points Try pressing the...