The second method of traverse is quite common but the first one sounds good as well. You will have lots of redundancy if you use 3 receivers.Levelling...
have used this beforeand it worked Ok, although not beautiful. The trial version was enough for me.
I don't think it's possible for it to center on the pole given this prism arrangement.If you need it accurate you must make sure one of the prisms is ...
Not sure why I said alignment instead of announcement there.
Zoidberg, post: 355265, member: 8841 wrote: No need to look through the scope anymore, the level displays a video image on the screen (with an autofoc...
beuckie, post: 355259, member: 2245 wrote: New levelling solution Seems interesting. Anyone have an idea what we can expect from this? Lieven No look...
rlshound, post: 355043, member: 6800 wrote: Hello squowse, Thanks, I found them where you pointed, do you use this much? Take video? Any advice? Thank...
perigon84, post: 354961, member: 2008 wrote: I am a surveying technician working for a crane service group doing rail analysis for large industrial cr...
Are you running the latest version of Access? The photos are now stored in a subfolder of the job folder.Screenshots can also be taken using CTRL+S an...
I have seen this, and like you fixed it and forgot about it.Are there any commas, quotes or other unusual characters (spaces?) in your descriptions?Th...
pdop 1.0, post: 354632, member: 459 wrote: Does Leica not have any active prism technology for this sort of application yet ? No, but if they did you...
party chef, post: 354601, member: 98 wrote: While mining the TS takes a continuous series of shots, first target 1, then target 2, or if 2 is blocked ...
downgrade receiver firmware?
Yep the topo drawing does state the basis of coordinates adequately. I can see that the designer hasn't rotated the topo on his drawing. (although he ...
i'm interested in the "LED shutter". What is this and how does it work?Thanks for all the photos!
geopro_consultants, post: 354568, member: 9959 wrote: Going from memory yes you can do it, the only challenge is that the 0,0 point must be entered as...
Mark Mayer, post: 354564, member: 424 wrote: Perhaps the thing to do is to set up a custom projection zone, which is easy to do in Access, and indeed ...
squowse, post: 354538, member: 7109 wrote: Bit rushed on this one and don't have the controller in front of me. There is an existing co-ordinate syste...