The salesman that is knowledgeable about the equipment they sell beyond the point of basic set-up, is few and far between. The way things are going wi...
I think you need to set up a new receiver profile in survey pro with the 5700 as a base rec. and the 5800 as the rover. You may have done that already...
37°01'58" N117°18'44" W
Survey Pro Repetition Shots (auto)> Aloha, Brian: It works! :good: Thanks to your detailed post. You are right, I had to do a bit of tinkering with...
:good: Have a great weekend!
send you "O" file...I think TPS2RIN separates the GLONASS ephemerides from the GPS and that is what the G file is.???
*.13o is the raw observation file. That's the one you want to send. The *.13n is the broadcast ephemeris associated with the TPS file.
Copy a version to of TPS2RIN into a folder that your *.tps files are in then select your *.tps files and drag them onto your TPS2RIN icon and drop the...
Survey Pro Repetition Shots (auto)You are very welcome. Yeah, you need a smart target with the infra-red telemetry at the backsite in order to operate...
Parani setup & Survey Pro Repetition Shots (auto)> Off topic...> I notice we have almost the exact setup except I am using Survey Pro 5.1.1....
Parani setup - PicturesPseudo- I have the on-board SENA batteries installed to each unit. I have no idea as to how long they last. I wanted the extend...
Parani setup - Pictures
Parani setup - Trimble 5600I just unwrapped two of these for use with a 5603 Robot. I have a TSC2 running Survey Pro 5.2. I have the Parani's dip swit...
> In place of the NCOPY express tool, you can open the source drawing and utilize the Edit -- Clipboard commands and paste the Clipboard contents i...
@ LarryIf you have a large multi-disciplinary DWG with thousands of layers and multiple x-refs, it's a handy tool to help cull out what you want to wo...
The Great State of Jefferson almost had it's day in congress. Too bad that little thing called WWII came along or it might have become reality.
This discussion reminds me of a time I was staking curb for a contractor, setting round hubs about 3/4 of an inch in diameter. After the staking was c...
How about the line or curve table on sheet 3 referencing a line of curve segment on sheet 6...:-@