For the most part it's the same staff. All the people I deal with just changed t-shirts when finnings purchased the construction side of KOREC.

+/-6mm is grade tolerence for binder and surface course.

Ah TCC now there's a topic.About 3 months after we started using TCC last year we started to encounter the sync failure. Eventually and I can only ass...

Hi imaudigger,Thanks for the due to the way in which I conducted the check measurements and the consistency of the inconsistency (Is that an oxymoron?...

Hi Roadhand,Though all of the prisms and diodes appear to be in good order and given that I insist that ALL of the hardware is handled as if it were a...

Hi Jim,thanks for the response. In answer my dH values are taken from co-ordinates calculated from single face measurements to each of the 8 prisms in...

Hi squowse,thanks for the response.ALL measurements are in STD mode (TRK mode used ONLY for general set-out op's)ALL of our instruments and those empl...

Hi James,You would think that but given that we have been asking them to tidy there designs for about 8 months now and several of the more complex des...