@rover83 What do you mean old-timer, here is a relatively recent photo of me using one.
Thanks Wendell
Hi Christ, Good to hear from you, hope you are safe and staying isolated.?ÿ I am going to look at this more tomorrow but I'm not sure it is a rinex d...
Thanks for that info, I downloaded TEQC a year or so back but never needed to learn how to?ÿ use it but I will give it a look.?ÿ This is GPS Week 2099...
How is it possible that a found original lot corner is north and west of anything, wouldn't it be the corner. ?ÿ
I had one come back yesterday with message that it was an 8 second interval.?ÿ I knew it wasn't and reconverted to rinex and resent and it worked fine...
Shawn, I feel the same way?ÿ - over the last 40 years I have had minimum interactions with the board and don't see how that will change by being part ...
Maybe a large diameter drill bit reduced to fit a 5/8" chuck.
I'm impressed with all the multiple state guys, I can barely keep up with just one county much less several states.
FL33404RTK, post: 426961, member: 11610 wrote: Ok guys so I've been going back and forth with my vendors on getting setup with a robotic unit. Curren...
In Civil 3D if yo go to toolspace > misc util > reports > point > points report > you can create a html report of the points in the ord...
I really believe Autocad doesn't think surveyors can add and subtract. Not sure about the 60% discount but their website has a 30% discount on C3D fo...
