AI Assistant
Activity
 
Notifications
Clear all
paul-in-pa
paul-in-pa
@paul-in-pa
Member
Joined: July 3, 2010 7:50 am
Topics: 700 / Replies: 5334
Reply
RE: I Dunno how many of you read the magazine P.O.B.

"Dave Karoly, post: 408942, member: 94"]My idea is to require a degree, but any degree would sufficient to meet the requirement. You could add some mi...

9 years ago
Reply
RE: I Dunno how many of you read the magazine P.O.B.

Quite a rambling article, but I will ultimately address the issues.First question, as a comparison, what is the average age of college professors?Assu...

9 years ago
Reply
RE: Louisiana Comity by way of Texas

TXSurveyor, post: 408851, member: 6719 wrote: Looking to apply for the LA exam. It's a pretty in depth application process so I have to make it count....

9 years ago
Reply
RE: Out of state surveyor

I had never checked for a temporary license verification and just went through the alphabet a to z to find 2 active temporary Land Surveying licenses....

9 years ago
Reply
RE: Opus question

Phil Garcia, post: 408820, member: 301 wrote: Here's a question for you. If an unlicensed individual performs an OPUS share sessionon a point and has ...

9 years ago
Reply
RE: Neighbor to Client

Tommy Young, post: 403062, member: 703 wrote: This is what I'd do.I would argue that going back and remarking a line is a different project. I'd like...

9 years ago
Reply
RE: Blunder detect runs in Star*net, but can't adjust network

rfc, post: 408119, member: 8882 wrote: Still have a lot to learn about the program.NO! You still have a lot to learn about surveying.Paul in PA

9 years ago
Reply
RE: OPUS and Earth Tides

"Except that Dr. Nievinski has told us that the earth tides are dealt with before the differencing, so they do not assume you go up and down the same ...

9 years ago
Reply
RE: OPUS and Earth Tides

Bill,Earth tides are effected by the sun and twice as strong by the moon and are generally less than ocean tides.Given that the orbits account for the...

9 years ago
Reply
RE: Driveway

Didn't he say that the County Roads were no longer open and maintained? By obtaining the state permit he had legal access and the county no longer was...

9 years ago
Reply
RE: OPUS and Earth Tides

Let me give this a shot.Earth tides affect the geoid relative to the earth's center. The geoid is established as a mean of the geoid surface, therefor...

9 years ago
Reply
RE: cross section stationing

Sounds like there should be PennDOH (Department of Highways) construction plans. I did a survey of a farm parcel a few years ago based on 1927 PennDOH...

9 years ago
Reply
RE: Trying out Carlson for Survey

If you use the "Points" pulldown "Move Points" command, the crd is updated automatically.The "Create Points Table" screen gives you many opportunities...

9 years ago
Reply
RE: rotate in carlson

John Hamilton, post: 407250, member: 640 wrote: I have a tangent, curve,tangent. I made it into a single polyline. I want to rotate it so that it pass...

9 years ago
Reply
RE: Topcon GTS-300 Manual Required

Reflective tape should get you a distance.Start with the basic data collector, an HP 48 with TDS or SMI.Paul in PA

9 years ago
Reply
RE: To GPS or not to GPS, that is the question

RTK is a big ticket purchase and you sound like you have done no GPS to date. Have you looked a an RTN alternative in your area, at 1/2 the cost or ev...

9 years ago
Reply
RE: Topcon GTS-300 Manual Required

Almost any Topcon Manual should tell you all you need to know. I think they have had the same specs for data transfer to data collectors for close to ...

9 years ago
Reply
RE: Why Should a Surveyor Use Civil3D?

If you are delivered all the points, breaklines, TIN and a topo you have enough to create your own DTM if that is what you need. I would not create an...

9 years ago
Reply
RE: OPUS height uncertainty?

No matter how good those numbers seem, the most important check is an independent re-observation.My preference is to GPS observe two other project poi...

9 years ago
Reply
RE: Why Should a Surveyor Use Civil3D?

The last time I had to edit a T.I.N. was in AutoCAD 10 before I bought Carlson SurvCADD. If you use breaklines, the TIN should follow the breaklines a...

9 years ago
Page 58 / 302