Last seen: June 3, 2026 8:38 am
There are a lot of unanswered questions in that one. Was the line the he monumented on a section line? Why would the "survey" be considered "unrecorda...
I always try to explain that just because you have two found points on your lot line it doesn't make them correct. I'll tell them that one could be in...
You bet, this was one of the best days I've had in 45 years of chasing the elusive lot corner. I believe they were set by Ethan Maxon, a county survey...
Then you should hear Elmer signing Bruce Springsteen, "I'm on fire" Or maybe it was Robin Williams doing Elmer. Its been a while.
@dmyhill For a while around here the utility company wouldn't put in the underground stuff until all the lot corners along that line were set. Not ju...
One county around here does Larado/Tapistry and its terrible to work with. Hard to find the right documents and they aren't bashful about charging you...
That one's a pooper. Around here ( SE Wisconsin)?ÿ they claim the only way to make that lot line disappear is by replat or Certified Survey Map (minor...
@bill93?ÿ Not really Bill. The guys around here just want to be able to square it up in the hole which is where the 3 corners come in. Now if its one...
@350rocketmike?ÿ In some areas around here the municipality does require stakes in the hole, they consider it a recertification which makes no sense ...
With the concrete guys around here I give them what I think they will need according to the individual job. If I ask them I'll be there two days staki...
I've done the same thing trying to slap a deer fly on my head. More than once. It hurts. Slow learner I guess.
I have found county sites in the U.P. but they were all different. Some more helpful than others.
I worked for a firm like that years ago. The head of the survey dept. would research the job (never visiting the site), this was before the GIS we hav...
We have a guy around here that always likes to do that crap. Was the rod perfectly plumb, did he use tripods over every corner, was all his gear calib...
Just got over one. Staking addition for next days work. Get a call, its not right, off by a half foot. Check my stuff and it looks good. run down and ...