Thanks Shawn!Old eyes and big fingers made creating this so much harder than just ordering a print ...

Ordered up some new colors for the Model 6 and the HDS6200 and will re-dye them as they are truly hideous.

OK, the tripod is very cool. It slips and falls down on slick surfaces just like a real one. Now if I can just figure out how to tighten the screw h...

Ummm, ... waffle, ...

Finished it up and will place it in service for a test. The screws I could not remember were 4 - 1/8" x 1" and 2 - 1/8" x 1/2". I actually sized the...

I have a couple of older Trimble/Geodimeter robots with the external battery. I want to un-mothball them as things are picking up. This is to replac...

I dyed the pieces today. The T3 is a combination of two dyes and looks much better to me.Dyed the legsDyed the Model 6 and tried a new technique. Le...

If so, I want a Kent McMillan and LR Day Action FigureI don't do people ...Actually it would be very easy to do, just laser scan to print. I have alr...

What your palette has set as 0 as plays into this, which is in the same file

Take a look at Blender. Open source and a good solids modeler

It turns out if you really cram a model full so it is very dense, after 20 cm³ they discount the cm³'s. By very dense, I mean greater than 10% of the...

This is the case I designed for the batteries that Peter suggested. I am planning on using the Geodimeter plates as a direct install and printing spa...

It actually works fine, I will have to screw them in from the top after they are soldered, but, they will work. I am up sizing them to a #8 ball plun...

> 1. Is the lift tab necessary? I note that the Trimble triple carrier doesn't make use of the detent at all -- the batts just slide in against a...