Thanks for that, I haven't really looked at the prism, so, a small hat may be in order.
The 8" is too big.?ÿ This is a pic of the 6" and I think that it needs to be a 5"
I think that the 6" (15.24cm) is the more appropriate one, although I have no feedback yet, but, it would be exactly half of that number to rod center...
I was able to get these on the printer last night, both the 8" pictured above and a 6" designed to soften the blow.?ÿ They are polycarbonate and I wil...
It seems to me that all you need is a slight variation of the mount that we have for one of our MiFi antennas.?ÿ Adjust it closer to the rod and make ...
We just had the prism fall to the dirt the other day when the 1/4" stud broke.?ÿ Why was there a 1/4" stud (like for a camera) on the 5/8" x 11 stud f...
We never had much luck with SurvCE to a 5600, but, I was fairly quick to return MicroSurvey as it ran it fairly well.?ÿ SurvCE ran the instrument at a...
HP is certainly not what they used to be, sad
You are describing what our Verizon MiFi was doing a couple of months ago.?ÿ Designed obsolescence was our issue as a new one fixed it.?ÿ
Chris, the fact that they would need to be collected afterwards was always a design parameter.?ÿ These were not designed for the rural survey, but, fo...
I have printed some targets, a 33" and a 22" and have been adding functionality as I think of it.?ÿ What functionality can you add to a target??ÿ That...
I would have a BRZ in a heartbeat as my daily, if I fit, which I don??t ?ÿ
We use a mifi units with antenna jacks and then port those to a variety of antennas.?ÿ We really rarely use one stronger than 4 dBi.?ÿ We have found o...
This is the smaller one for a 1.25" rod that I will print for my crews.?ÿ I did increase the standoff so that feet washers of 3" diameter could be use...
Us old timers know that it is a great way to learn and I do take those opportunities.?ÿ Still, I hate being wrong, LOL
So as I am drifting to sleep last night I am thinking about this thread. Obviously there are issues there beyond surveying, but, back on topic. I have...
Use the snap on top for a 9v and dare I say, a small bungee cord ...?ÿ Sorry, I 3D print everything I need anymore.?ÿ If you have the desire to print ...
That battery has two tiny screws that hold it on.?ÿ If you look at your Parani you will see a back cover held on by two screws and yes that is where i...
Jim, I figured you did know better, Lol
Snap connectors are a source of failure (wtf it doesn't work frustration) and are more prone to corrosion, please solder.
