Google Sketchup?

> Is there a free desktop utility to batch process say 4,000+ points that currently have ellipsoid heights and need to be converted to orthometric ...

> I used to have the HP450 service manual which I used it to replace the belt. they have a troubleshooting guide in the back. You should be able ...

> It really does suk. > > I have entered agreements that required "electronic files" as part of the deliverables. Unless they specifically re...

In my haste to write the post, I typed agreement instead of adjustment. I meant an adjustment, of course.

This article covers one that I found.

> We just started using a Trimble R6 gps receiver. On each job, it assigns a point number one to 5000,5000. This point is always about 300-325 mi...

Are you referring to Mount Parking Stripe, or the contour running through a building, or both?

> Anybody using a Subaru Forestor for surveying and can you give some pros and/or cons? I'm working solo and occasionally need to go off road where...

> Anybody have a rule of thumb for distance adjustment to a non-tilting prism? Something like "20 deg. slope add 0.03'" ? thanksMaybe I'm way off h...

> Most plats I've done use a "pony"--another drawing from an earlier similar project. Then I take the pony, make all the changes for the current p...

> LightSquared to cut staff by 45 percent as troubles grow > ENGADGET | FEBRUARY 21, 2012> > > Yet another bit of bad news to add to th...

See this link.

Good point concerning the expertise; definitely hire a consultant on this one.