I imagine your map will have a lot of notes that will say "found per 2009 survey and not accepted". 🙂

Agreed 75.33 ft or 22.96 meters

Just guessing here. Volume all the way up? Tried all the sensitive settings? Check the wires to the speaker? When you tap the rod sideways does it mak...

Could that "no magnetic signal" be one of the reasons for a few of the pin cushions we find??

For the record I have never found such a pipe so how does one drive a pinched (crimped) top pipe without destroying the pinch? Back in the 80's the of...

In the 60's in the Forest Service we took sun shots with a 1 minute transit using the horizontal and vertical angle method and the leading edge of the...

1.) Load the txt file into Excel and make 2 columns, Lat in A, Long in B. Save As CSV. 2.) Open Google Earth and File > Import > Find the CSV...

I have had several smaller versions of this where I went with "intent". I would be tempted to hold that mon (that's 8 feet off for distance) for line ...

Another option (not as good as what @pls8xx wrote) if there is not another good spot where you can shoot everything would be to reset the TS at a diff...

Same here. 50% retainer plus they sign the estimate spelling out what they are paying for such as a boundary survey sufficient to accurately calculate...

I used a 3805A with a T2 for several years. I wrote a program for my HP41CX where I could set the 3805 anywhere near the T2 and enter the H & V &a...

Yes, in meters.  

The 2 poles that mattered were only 120 feet apart on each side of a new 2 story ADU where I was setting offsets for construction. I doubt temperature...

[/quote] Can you post a small piece of a FieldGenius .raw file? [/quote] Here is a piece of a total station (robotic) raw file. --FieldGenius ...

[/quote] Can you post a small piece of a FieldGenius .raw file? [/quote] Here is a piece of a GPS file. --FieldGenius v 10.4.1.2 (2020-08-13)J...

Only if you just shoot each end and try to calc the sag. Using the Vertical Plane Projection Intersection I shot points every 20-25 feet along the wir...

How accurate were your temperatures?? Or maybe you can correct the 2mm with a bogus temp setting?

Very nice but way too expensive for me. I have switched to 8' bubbles in my bdy rods instead of the standard 40' bubbles. Same bubbles as the ones in ...