Last seen: June 3, 2026 5:06 pm
This uncertainty of whether the error is in the starting point or the ending point is why IMHO this is always an open traverse. The only way to not ha...
In my software, PCSurvey, each traverse point must be connected with an inverse in the order that the traverse was run. Then those inversed lines must...
yes I do it all the time. A great time saver.
If you are staking a bunch of random points like maybe streetlights in a big parking lot I would use the traverse routine. First I would look at the o...
If I'm staking line for fencing I bring the nails/hubs into the client property 0.2'+ and the lath say fence line or fence corner.
Ya, time spent billing is the worst part. I charge portal to portal with no extra charges for mileage or reference maps etc. Makes for a pretty simple...
The intent of a CC is that they thought they were on the township line when they set the stone. The next GLO survey states that the CC is 8 ft south o...
Wow SDR33. I used one with a Sokkia Set-2 way back 1995-1998. Memory is very weak but I think the baud was 2400. Later on I connected an HP48GX w/TDS ...
The NE.Cor.Sec5 was not set because that would create a no-mans-land. Using a split between the SE.Cor.Sec32 and the E1/4.Sec5 to set the NE.Cor.S1/2 ...
Check Google. There are phone adaptors to telescope eyepieces but TS eyepieces are too small and the phones are too heavy. I tried 2 different types t...
I'm in the middle of a tree survey. All big oaks 24-36" with a few at 48". Drip lines out to 50ft radius and hanging down to 2-4 foot above the ground...
Ya I had one of these a couple years ago and the embarrassing thing is I did it to myself. I did not get back to putting the data in the computer unti...
This might be your answer from @john-putnam
Rent or borrow a different GS18i and if stays connected for a week then the problem is your GS18i. If it disconnects then the problem is your CS20.
Maybe just turn on tracking?
Page 11 figure 8 shows a calibrated wooden rod. What was the procedure used with these rods to measure the baseline?
Very interesting. I have never seen or used any equipment like that. Why the atomic clock?
Here is a wild guess. Turn on all the layers. Maybe the cogo routine uses a special layer.
There is another problem with that deed. If the first 3 calls are correct then the last call of NW'ly 148 feet is not possible. It needs to be NE'ly.
Same here. Got my first PC Survey licence in 1999 and have updated now to v23.2.1 which is not the latest but it does everything I need. Also the conv...