I tried Dragon Naturally Speaking several years ago thinking the same thing. My results were less than desired. After a lengthy "training" cycle where...

> Just got this e-mail... Confirmed. The Better Business Bureau even has an article on their web-site that discusses the issue:It’s Still Out Ther...

> Now, anywhere I place the mouse, it acts like I have selected it, or sort of acts like it. > >> > Anyway, how do I get it to "Act nor...

irregular areas averages> Ladd's NE pile calcs differ because he didn't use breaklines along the "shelf", and instead connected all the higher poin...

LaddHi Brad,I don't know if there is a "right or wrong" aspect to your approach. However, here are the steps I followed to obtain my results: Brought...

Andy, I've got a great idea...I took some liberties with the points and subsequent breaklines that defined the two piles:With this information, here i...

Carlson Knowledgebase article 28 should work:If you're unsure which toggle is the Dynamic Input toggle, I've highlighted it below:--Ladd Nelson

> My Carlson Survey 2011 with embeded AutoCAD does not have Textfill or Fillmode?For some of those "hard to reach" places, check the System Variabl...

You might try checking/setting these values (note that some variables would need to be accessed through Settings -- System Variable Editor):SHADEMODE ...

I'll defer to the intent of the solution (and concede multiple solutions) as point #6 is/was also obstructed for (hopefully) obvious reasons. I took s...

> Measure and additional point 4A on line 4-5 and draw a line perpendicular from 3 to line 4A-5 to get point 4.Another option would be to use the J...

> The red hidden lines are the suggested RL lines. Thank you.Just for clarification, can you elaborate on the meaning of "RL lines"?--Ladd Nelson

Although I wasn't the original author of the various Carlson tutorials, I worked through them several years ago and will be happy to take observations...

Here is what I got when I ran the Draw 2D Polyline routine:>Command:2dp>[Continue/Extend/Follow/Options/]: 1>PointNo. Northing(Y) Easting(X...

If you go to Help -- About Carlson, what build number does the command report? The build number is in the date form of YYMMDD. Make sure your build da...

I have a solution involving the "PasteSpec" (Paste Special) command but the solution requires upgrading to Carlson Survey 2010 or later. Furthermore, ...

I don't have direct access related to the type of content that the Carlson programming team would (or does) contribute back to the IntelliCAD Technolo...

Autodsys' $99 CAD website...Ladd NelsonThe contact page at www.intellicad.org states their place of business as:>The IntelliCAD Technology Consorti...

I'd like to take this opportunity to clear up a few misconceptions within this thread:> my understanding is that IntelliCAD is Autodsys, so, basica...