I had heard that as well for various manufacturers.I actually went on a tour of the factory near Stockholm in 2008 where they make the S6. Very intere...

Holy Cow, post: 442524, member: 50 wrote: Well, then, you need to travel to the extreme northeast corner of Kansas. Why, you ask? Because that will ...

I hope to be above the clouds if there are any.

I would certainly like to consider a Leica, but at this point I would have to get a new data collector, learn new menus, etc. Getting to be too old to...

That is true. The fine lock is spec'd at better than 1 mm at 300 m, so it is not like we would be doing any manual pointing. The tradeoff in the S9 li...

I proofread the first edition (not by request, but since I read the book cover to cover and found some errors...). I wonder what the differences are b...

She was apparently a very good roller skater, she did a show with a male partner. My two kids thought that was the coolest thing, that their grandma w...

John Putnam, post: 442399, member: 1188 wrote: John,A little off OP but I think you can get your dad's military records online. My brother just got m...

J. Penry, post: 442372, member: 321 wrote: I'm headed to the WWII Fairmont Army Air Field. 40?ø35'31.5" 97?ø34'21.0". This is one of the best remai...

like I said, we can land way outside the area and get fuel. Fuel endurance is about 5 or 6 hours (depending on power setting). Bladder endurance varie...

Gene Kooper, post: 442274, member: 9850 wrote: Pictures, or it didn't happen! ;)I won't suggest that you fly out to Alliance, NE for a visit. The ai...

I will be in the air, I am hooking up with a fellow flying club member (we have three planes) and we will be flying around over either Kentucky, Tenne...

Doing both CMR and RTCM used a little over 2 MB per hour, of course that could vary depending on how many satellites are being tracked. So in one mont...

OK, so RTCM 3.0 only...it is 1.02 MB for 60 minutes of streaming. That is GPS and GLONASS. I will try to do both CMR and RTCM next....

I believe it would be enough. I don't have an answer to the first part, but 5GB should be enough. 5 GB is about 6.7 MB per hour, 112 kb per minute. I ...

JOHN NOLTON, post: 441686, member: 225 wrote: J.H. Thanks for the post and the explanation. Trig leveling is out. One thing is you are lucky that you ...

John Nolton: Trig levels would be a possibility. Maybe. However, there are several short segments with 90?ø bends (I think there are 4 or 5 turns on t...

I will make a note of the data usage next time I connect. I have a subscription to one VRS where I have 100 hours over a year (cheaper than unlimited)...

Yea, I wish I had a Mekometer to play around with...I did use a 3000 modelMy guessestimate would be 3' X 3'. The required accuracy is not specified. H...