Kent McMillan, post: 385269, member: 3 wrote: and the types aren't specifiedThe rover antenna is listed in the RW5 header as a CHCX91R. I don't see ...

Kent McMillan, post: 385263, member: 3 wrote: I see that the vectors are rendered as PC to PC with the antenna heights.How can you tell that it's PC-P...

Tom Adams, post: 385187, member: 7285 wrote: They often have a hard time accepting that lot 2 of block 8 of the xx subdivision can be a legal descript...

Norm Larson, post: 385237, member: 7899 wrote: Jim, you have gone 3DI upgraded my BricsCAD license when I decided to 3D print some little gizmos for m...

I hope the tracking systems improve over time, but even if they become reliable, I'll remain an adherent of the "ounce of prevention" school.

I think Leica still holds the gold standard with its Disto line, but none of them are going to be readily visible in bright sunlight over long distanc...

Kent McMillan, post: 385169, member: 3 wrote: Trimble's yearly "maintenance fee" basically amounts to insuranceTrimble hasn't gone as far as Autodesk,...

Kent McMillan, post: 385126, member: 3 wrote: What I'm asking about is a utility to edit RTK vectors (change antenna height or disable vector entirely...

Shawn Billings, post: 385099, member: 6521 wrote: You'll need to be careful with that. Are the exported vectors mark to mark or phase center to phase ...

Nate The Surveyor, post: 385094, member: 291 wrote: You screw them in with a battery powered screw gun. Then, attach valuables.Among the many hare-bra...

Kent McMillan, post: 385036, member: 3 wrote: or is its import capability limited to just Ashtech-proprietary RTK vector formats?It'll take RINEX, of ...

I see the SV on/off control, but without being able to see the noise levels of the SVs in the solution, messing with SVs is kind of flying blind. In ...

Kent McMillan, post: 385007, member: 3 wrote: I trust that it preserves descriptors in the vector record?It doesn't, unfortunately -- only a 4-charact...

Kent McMillan, post: 384988, member: 3 wrote: I haven't installed GNSS Solutions yet, but aside from time windowing, selectively disabling SVs, and ra...

Kent McMillan, post: 384996, member: 3 wrote: I believe that you've mentioned before that you also export RTK vectors for adjustment in Star*Net. Do y...

Mark Mayer, post: 384966, member: 424 wrote: Not super cheap.Not cheap at all, unless you're comparing to Bernese or GAMIT/GLOBK.