I asked about this from Leica few years ago. The triangle shaped mirror "centers" on Leica type 360 prisms (GRZ4, MPR122 etc.) are offeset from prism...
Hey, for me it goes something like this. Internal accuracy of your control points is what matters most when it comes to construction. Best way to ac...
Hey, Im not quite sure what you trying to say. Try to be more specific. Are you checking sticker target heights with GMP111 backspike or what? Few ...
@johnymal No, i dont know anyone. I believe SurvCE is not very popular in Europe.
Hey, Ive been using Leica Icon for about two years now with MS60. Before this i had captivate for about 3 years and smartworx before that. Few flaws...
Id forget the plumbs/zenith lasers etc. Setup total station to the elevator pit and run upwards with a prism pole. Stick it inside elevator shaft at ...
@jflamm Measurement mode has nothing to do with this issue. Im talking about separate distance measurement and angle recording. Normally with leica...
Noticed that Icon distance measurement doesnt lock XY into place after measurement like captivate does. If you shoot on vertical facade and start roll...
Sticker range issue could be that ICR70 has R500 laser while the TS16 i used had R1000. ICR70 has hard time measuring past 50 meters to slightly angle...
John has is right. Measure FN->2face stores an average which cant be split Storing face1 and face 2 with the same point number creates 3 invidual p...
PPM starts to matter when your measuring longer distances (100 meters+) or doing something extra precise like control points/industrials etc. I usuall...
@squowse This is correct. If you shoot angled wall shots the distance reading is taken slightly off from the center of the red dott. Same is t...
If you are doing reflectorless staking on walls keep in mind that the measured distance starts to get bad after about 45 degree or so. This is because...
Hello,I called to leica support few years ago about grz4 elevation problem. Depending on which mirror you aim at the height is +2mm or -2mm.The explan...
Hey,As some others have allready pointed out in earlier replies: Trimax legs are a lot more vulnerable to sunlight and changes in temperature than Lei...
squowse, post: 400162, member: 7109 wrote: Yep. It's more likely to affect the centring and horizontal angle. Which the instrument can't compensate fo...
Hello,During the past 6 years or so i have used both Crain Tri-Max and Leica 120-9 tripods daily. Last summer i noticed that trimax legs are alot more...
