I resolved this issue by creating a new drawing and "inserting" the old drawing.?ÿ No problems now.

1) Not?ÿ a locked layer 2) Ran an audit, then purged, no change.?ÿ exited the dwg and the program, re-opened, no change.?ÿ audited again, purge again...

45, after 18 years at another firm "learning the ropes"?ÿ 🙂 ?ÿ ?ÿ

@glenn-borkenhagen Thank you!!!    

@va-ls-2867 when I am in paper space and click on the model space view line the left hand screen shows options, including one called MISC.  Unde...

@monte It does not return to the former view.  I have to re-set the model space viewport  

@bstrand Yes, the view port changes location and I have to re-set the drawing.  It is a matter of keeping the item visible in the middle of the ...

Hasn't the Leica 1200 series been discontinued and is now unsupported??ÿ ?ÿ ?ÿ I have the TS 12 and am very happy, the TS15 would be awesome.

Now that I've taken a better look at the tidal benchmark data, is it correct to read the data summary sheet, where it states "North American Vertical ...