Last seen: April 10, 2026 9:41 am
i got kicked a similar one recently - two brothers had bought a gas station out in the relative boonies.?ÿ TxDOT comes to them in the course of the de...
I believe he lives in Wimberly now.?ÿ He's active on Facebook, you can probably get through to him there. In these parts moving to wimberley = hanging...
psst, kent doesn't care.?ÿ (he's re-re-ret...?ÿ i can't even type the word out.)
i'd tell him that if he hadn't been in such a hurry that you coulda sent the crew out the day?ÿafter?ÿthe rods get their weekly tip honings.
uh...?ÿ i reckon i figure it's usually a bidding situation on calls like this.?ÿ and i assume i'm usually not the cheapest.?ÿ and i still get enough o...
jim's right- though if they didn't generate the contours into those funky whatevermacallems, they'll convert fine in trueview.?ÿ that's all i ever car...
And just now another- ALTA on a c-store delivered in a week for 2k! (I said 5.)
DWG trueview (I think that??s what it??s called- if you search that it??ll find it)- free software from Autodesk. Open it in there and convert it b...
right- i stated that incorrectly.?ÿ i accept the case law, just in the particular situation i was talking about it was used in combination with some o...
unfortunately there's no web link for the case, but here's a link to relevant texas case law in a situation like this.?ÿ ?ÿ ?ÿ short version: an expl...
of course.?ÿ my only point is that i equate, for billing purposes, a robot at 1:1 to a human i-man.
lemme expound further on my thoughts, now that i'm not half asleep and just got out of one of the worst CEU seminars i've ever endured: in my opinion ...
Why should it be any less? You??re ultimately providing more efficient service when all factors are considered. In the end your clients?? cumulative...
this is on point to the discussion i was having with my instructor last week, in the middle of hood-work.?ÿ i said, basically: "i have no clue how you...
captivate is a good bit better than viva was, and viva was darn good.?ÿ disclaimer- i've run leica exclusively for the last 5-6 years (save a few rent...