Last seen: June 6, 2026 6:00 am
Andy, I've got a great idea...That sounds like a good idea, think I'll try it next time I've go about 50 to do 😉
Send the 3d points to me, I do em all the time. I assume they didn't give you a conversion factor from cubic yards to tons. Better to let them do th...
Do not overtighten, only need to be snug. Was told this by a Trimble repair guy.I had a screw rattling around in my TCU for a couple months after I g...
Now here's the kicker in all this....Since this contract was let, I believe Ky. has gone to SPC and dropped the PC business. However, I think they al...
Now here's the kicker in all this....4 zeros in that factor, not 5 as shown on the plans. I think the answer revolves around that.A couple of years a...
Hmmmm, you are correct....The easting agrees, northing doesn't. There was another control point like that in their list, but neither point was ever u...
Yeah, that was a typo on my part, it is 80.54 on the plans.The factor they used and put on the plans is obviously wrong, I think there's an extra 0 in...
> > Didn't calibrate to the site, no need. Had SPC, and they checked with each other.> > You had SPC which is fine AND...you had project ...
See my 05:53 post, I think that's where the screwup was. They had to have converted from SPC to project coordinates for design, then back to SPC in o...
I'm seeing a possibility here...The factor on the plans is 1.0000057236. The sets of coordinates check using that factor.Suppose there is 1 extra zer...
Didn't calibrate to the site, no need. Had SPC, and they checked with each other. Had project coordinates to stake averything else with the robot. ...
Didn't do a here. State Contract is to build the job from the provided control, which is identified on the plans as SPC. Did not do a site calibrati...
Matt SThanks to Leon, he got me going, although there may be a better way. Email the info to the address in my profile and I'll check it out.Thanks
LeonI figured it was in there somewhere, but I can't figure out the method. I have it all drawn, just can't seem to get it to work. I have to create...