I built a contraption a few years ago for profiling pavement. ?ÿI've only used it with a robot and prism, but its just a trailer with about a 8' tongu...

A height entered as feet instead of meters?

From what I can tell from that drawing, the 70 deg. skew is off the other baseline (I assume it's off the tangent since it's just before the PC, even ...

Im not following exactly what you are trying to do, but in a curve I usually put the radius point in the file so I can turn off skews to a curve.?ÿ

If you've taken off to the south from Vegas airport in the past couple years you've probably seen this.?ÿ ?ÿ

For the intersectiong alignments, youll probably have to create points at one end of each line, then do a bearing-bearing intersection in COGO.

Go to KEY IN,?ÿ when it asks for point name, hit OPTIONS at the bottom and change it to STATION and OFFSET.

Access will work with SPS instruments, I'm using it.?ÿ On my TSC3 I had to purchase a $200 code, but when I got a tablet last year I believe it was in...

Ive set probably 100 miles of blue tops using Lenker Rods.?ÿ?ÿ Used to put a rodman and hub driver in each lane of I-24 and swap back and forth, readi...

I was basing my comments on this statement you made. "Last week I had to do one for a job that was about 300 miles away and never left my office. I do...

Posted by: JaRo Several years ago, I figured out a way of doing a site calibration without ever actually doing a site calibration. If I have a job in ...

I'm going to get some popcorn....

You asked about hub and tack so I assume you have to leave an accurate point on it. ?ÿIf a 6" hub won't go, I use old railroad spikes. ?ÿDrive it in, ...