My company uses DR with the total station. Transmission lines are usually pretty easy to get a good shot on. Our engineers request us to shoot attachm...

Pull up your pants and stay off your phone. Don't make the party chief wait for you. Pay attention to what the party chief is figuring. Most good I-me...

Use a 2 meter tripod. Take the guess work out of it. Sounds like you are splitting hairs over a millimeter or two with a receiver that isn't as accura...

The way we handle this is explode the figures. Convert 3d polylines to 2d and then flatten. When surfacing, we use proximity break lines and don't con...

Could you possibly see the 2 building corners from your control network? That way you could assign coordinates from your control and then resection on...

FlaSurveyor, post: 355079, member: 10854 wrote: Lol! Yep doing a job here at S.R. 50 & Mercy Dr. And have heard all 3 in the last 2 days.I worked ...

Try wblock instead of export. Save it as a 2010 DXF. I think it is a little cleaner than the export command and always seems to work for me when expor...

I know when you check a point "control" on my Trimble controller, it will let me just export control points to another job. I would think magnet treat...

I believe I have occupied that point in Cedar County Iowa..

What is running on your tsc3? Trimble access or is it something else for machine control work? If it is running Trimble access, you should be able to ...

Not sure if it is a fictitious location, but the rest of the names on the crew lead me to believe that it is. Short and Long are chainmen, Sharp and D...

2 chains, 42 1/2 links.2.425 chains = 160.05 feet

I have an 8 GB USB thumb drive that my tsc2 will not recognize also, but it will see my old 4gb. Try a smaller thumb drive. The older models can't dea...