I want it to be a drawing entity that another cad user will be able to see when they open the drawing......won't have to bother with points.

120 channels is far more than you need now.

Love the idea and am not a bit concerned about taxis. Moving people around efficiently is far more important to me and this does it.

So there is a way to do a standard resection as if I were using the total station? When I've localized on points that I had not previously verified it...

Yep, I have to recalculate a lot of points due to that very problem. PITA!!

It's really a shame that Trimble won't give Carlson the necessary information to run it but I suppose they think they have a good reason not to (plain...

I would never bother with a topcon again I don't think and I too used them for many, many years exclusively. I'm going to demo both the s6 and Leica r...

I'm looking into getting a new robot (currently use a trimble 5603) and have heard a few bad things about the s6. My dealer/repair/service guy I use h...

That seems much more reasonable than what's being asked here. I too often see bolts out up to a half inch.

I agree that it can be done but my question is can the contractor get them that close.

I looked and there doesn't appear to be nearly as many ethanol free stations in Texas as there are here, which I find strange. There's two ethanol fre...

I agree. How in the world he expects .01' between any two bolts on the project is almost dumbfounding. The closest bolts I've as-built are typically o...

I only use boat gas for every single motor I use (chainsaw, mower, hedge trimmer, Kawasaki mule, boat, jet ski) since they aren't used every week. Boa...

I'm just saying that any union that is that into criminal behavior, I think this one was the teamsters, local unknown, should be abolished and severel...

I know that it was about money because the union was on strike to try to get pay raises. My uncle has 9 kids and couldn't afford not to work so when h...

Now THAT'S a cool vegetable murderer!!