Thats welding rod, everyone knows that.

I can't help but wonder of the OP is not from the United States. If he is, he needs to work on his English. If he is not, then he deserves a little ...

That's a half shaft of a 34 Deere tractor. Actually I have no idea what it is.

My experience with Topcon RTK is it is almost always better than 0.20 vertical. I would say 0.10 isn't uncommon but it usually does better than that....

The Illinois conference is coming up and I believe they have classes to meet the Indiana requirements. Google IPLSA and take a look, its coming up in...

There is an area near Havana Illinois that I believe also has no natural drainage outlet. Its kind of strange because its only a few miles from the I...

I've rarely ever set the center section by using the intersection of the quarter corners, there is usually some kind of evidence, a fence corner, ston...

For almost all the work I've ever done, the accuracy you achieved is good enough unless its some kind of special projects. Using a turtle usually giv...

0.007' off and your worried about the spec? Are you just curious about it or are you worried the gun is out of spec? Its just me thinking out loud b...

Probably, but from experience, the first time you do anything in 3D will take a lot of time.

I'm probably not going to explain this very well, but you can set up a drawing to work in state plane coordinates but all the distances you would list...

I'm always a big skeptic and I tend to doubt how effective the homeopathic stuff is, even though people swear by it. The shots they used to give you w...

I've seen that same video clip used in about 6 other videos. Its classic and there are so many things you can fit it to.

I've set a lot of bore stakes at a nearby landfill. Assuming its in an open sky area, its something that would take me 4 hours or less alone. This i...

LRDAY, I like your post. As I have gotten a little more advance in my experience, I have tried to be less ambigious for the reasons you stated. If y...