I used JaRo's method, which is of course brilliant in its simplicity.?ÿ I'm west of the principal meridian in Illinois and after I used this method an...

It for the foundation of the tower. ?ÿI already know based on the past history of this project no one will be able to answer any of my questions. ?ÿI ...

Iƒ??d want most of the money up front.

I think I found a program called NCAT on the NGS website that gives the convergence angle.

I'm pretty sure someone hired a Fung Shui consultant to design that parking lot.?ÿ I bet if you walk out there it just feels...ƒ??ƒ??ƒ??...right.

The couple of times I've really had problems with multipath was around water.?ÿ This was also more than 10 years ago and I suspect the improvements in...

I'm betting a lot of engineering companies have owners of which none may be land surveyors.?ÿ?ÿ As long as the owners let the surveyor do his job as r...

The entire thing sounds like a joke and the city should forget the requirement.?ÿ Seems like in a case like this the city should wave any requirement....

I have a Dodge Challenger I only drive once in a while.?ÿ Earlier this summer I took it shopping and left a bag that had 2lbs of hamburger and two New...

First off I always use a mask angle of some kind, usually 10 or 12 degrees.?ÿ I have seen multipath give bad results using RTK, but it was always in a...

So it looks like they were off by a factor of 10.?ÿ I read Undaunted Courage and found it to be a tough read but made it all the way through it.?ÿ I'v...

My general experience with a traverse adjustment in C3D is crash, followed by a reboot.?ÿ As far as I know it doesn't work.?ÿ

Around here if you get tired of looking at the corn fields, there are the exciting soy bean fields. ?ÿ

If you were closer I'd offer to bring my John Deere tractor over and erase that sign for you.

One thing I found is that making a surface and contours is better in C3D.?ÿ When you make changes, such as say adding a break line, the contours chang...

You might want to get some ideas or see if the trainer has a base drawing set up.?ÿ If you have a good drawing to start with it helps, that way some s...

I looked at the mission planning and it looks like I should have been tracking 20 something satellites, which it was tracking them, but just using 12 ...

I was using a base rover Trimble R10 today and it seemed like I was tracking less satellites today, its not uncommon to have 18 to 21 and today it was...

I was running Trimble R10's today as base/rover, for about an hour no problems but these are only about 4 months old.