The REALLY correct way to measure is to set up the tripod with the head level and over the point. Then measure down through the hole in the top of th...

John, that was probably Roger Frank from Johnson-Frank Associates.They did a large boundary job where Los Angleles, Orange and San Bernardino counties...

16 D&RA set of 16 D&R is measured by dividing the half circle into 16 parts and then advancing the plate 11°15'± between each set.The whole ci...

It's not the angle and distance you measure, it's what you do with it that counts.Angles within 30° of 0° and 180° have sines that change very rapidly...

Found original lain over. Reset ...

Thanks, PaulI always get a message to the effect "Do you really want to skip 1001 points?" if I accidently number a point with too many digits.

After reading all these responses I had to go check my desk drawers to make sure that wasn't all my stuff you guys swiped.Anybody need an almost compl...

Are you paying by the hub or by the hour?

Oops!You're right. I mistyped it. Angle 1-2-8 is 10°.

I did it without coordinates.Draw a line from pt. 2 perpendicular to the lines emanating from pt.5 & pt.3, crossing the line from pt.5 at pt.8 and...