The 5600 informs you when you run the when you are not close to 90 degrees when you run the optical collimation (within 5 degrees, I think) and within...

squowse, post: 392151, member: 7109 wrote: Yes refraction / shimmer could be significant at this distance in a poor environment. Underneath a bridge s...

as far as I know the laser return is slower in wet cold air that it is in hot dry air , so I gather it is important to have these values set correctly...

The din standard for this instrument is 3" per pointing so no I am not worried about 1 second. I have to admit that I was not paying close attention a...

Well there are two parts to the question. What is the impact of heat on the diode signal? What is the impact of heat on the laser to and the return fr...

thanks Digger. I am aware of heat waves, while the heat waves appear to cause the image in the scope to shimmer, the instrument tracks the signal emit...

The RMT emits a signal from the diode(s) that is received by the tracker in the instrument. The software knows where the center of the glass (reflecto...

what about private property rights? No mas?

its on the bottom

A fence may or may not be evidence of a boundary location. The evidence of a boundary location is evaluated and weighed in order to form an opinion as...

If you are going to just report a record distance no matter what you actually found, then why does the public need your service? Boundary surveying ...

Lon was very helpful. + 0 and -0 did the trick I am using the Autocad engine for 2016 Stand Alone 02/05/16

I have set the special code fro begin line as +1 and end line +2.....there must be a check box someplace that makes the software think I want to fit ...

See if you are able to hook up with Ric Moore, Ca. If Ebay gets a letter from the State of California perhaps that well get their attention. Ric has b...