Check out the Battery Fly website under GPS batteries. We have used them for our R8 batteries for a few years now. Almost as good as the Trimble batte...
For topo and stakeout: Trimble S6, Trimble R8 models 3 and 4, TSC3 with Access. For woods traverse: Leica TCR703 (very light and fast to set up), Trim...
Can't speak for the S7, but our S6 is very dependable and well built. So is the Active Prism. The only issues?ÿare the crappy tribrach that came with ...
Get some Crain legs and Leica tribrachs. Every time we get a new Trimble instrument, the tribrach it comes with goes into the "junk box". It is disapp...
StarNet will only read the .dat file. There are ton of StarNet gurus on here. You need to explain what error message(s) you are getting, maybe some sc...
Hi-staker, post: 443105, member: 8208 wrote: I will take it! Paypal work okay?Thank you! If this deal doesn't work out, I can hook you up.
J. Penry, post: 436330, member: 321 wrote: I scored 39 out of 44. 40. Some guesses.
I. Ben Havin, post: 431166, member: 6834 wrote: Got a power transmission line project coming up where intersecting cross power lines will need to be m...
m & h taylor, post: 365797, member: 239 wrote: We found a mark today just south of Santa Fe, at N35 35 28.15193, W 105 54 10.67959. PID FN0701. ...
spledeus, post: 363167, member: 3579 wrote: My first run in was in RI. 3 firms performing layout work and one used I.Ft. We were the last and the bu...
John1Minor2, post: 353500, member: 404 wrote: I have an Android cell phone but only use it very occasionally. I looked at putting Skype on it so I cou...
Anelis Acosta, post: 332052, member: 10365 wrote: Hi, I would like to introduce myself as a new member! I'm originally from Puerto Rico. I move to the...
Less than you would think.
We have an S6. Zero negatives about it in 4 years. Absolutely worth getting the active prism for it, you will pull your hair out trying to use the pas...
With your GPS on or near the point you want to review, go to map, click the up arrow at the bottom of the screen next to Measure, click Pan to, set sc...
