@tyler-parsons Thanks Tyler, I went to the hardware store this morning and found that the center thread is actually metric - M6 x 1.0 pitch.  T...

@stephen-ward In the picture on the right, I believe the prism is upside down.?ÿ The picture on the left shows the top of the prism.?ÿ I want to moun...

I spoke with my Topcon dealer, and they suggested that the pen accuracy problem may be due to the device not being fully updated. I checked Windows Up...

@tom-wilson Thanks, Tom.?ÿ Panasonic's pen for this tablet doesn't have the rubberized end, but I agree I might get such a pen and put the screen in t...

@bill-c Good writing, Bill.  I don't own a copy of Bobrowski's book, but I too looked at the Google Books result.  It's obviously a complic...

Both an independent Toughpad dealer (The Rugged Store) and Panasonic themselves suggested that the issue is likely software (Magnet Field) related, an...

@bill-c Hi Bill, Check out A reference to the case was provided to me by a clerk at the Land Court.  The court concluded, after reviewing spe...

I had to do this once.?ÿ The subject property was made up of several parcels of land, all registered in Land Court, and the owner wanted to put an add...

I upgraded to Magnet Field v6.1 (build 1912171452), but the problem with pen/stylus entry persists. I noticed something else though.?ÿ The pen that Pa...

Lee, Thanks for your response.?ÿ I'm upgrading to Magnet v6.1 now - hopefully, that'll help.?ÿ I'll post my results. When you have a problem like this...

Use the GPS or Total Station to get you to the approximate location.?ÿ Then, abandon the equipment and use your eyes and feet.?ÿ Don't spend alot of t...

@hollandbriscoe I also have a DesignJet T120. I would say that I have had problems with ink clogging. I have generally used cheap cartridges though. ...

@hollandbriscoe Why do you think using off-brand ink is likely to cause printhead problems?

I was able to update the firmware on the Hiper Pro receivers. Topcon made a good solution for this issue.?ÿ I was able to find the Hiper Pro in the "...

?ÿThank you Lee. I was not aware of that. Now I have something to investigate. I will post back and let you know how I make out.?ÿ

Subscribing to the topic.?ÿ Is there a way to subscribe to the original post after it has been posted without having to write another post?

In all fairness, the service manager was answering a (rather dumb) question I had asked him - whether his process was to adjust the frequency of the E...