Shopping Cart

No products in the cart.

Shopping Cart

No products in the cart.

LEICA GS10/15 GNSS BASE

  • Ask A Surveyor

    LEICA GS10/15 GNSS BASE

    Posted by kwame-poku on December 12, 2018 at 12:44 pm

    Hi guys,

    I have set up a Leica GS10/15 base and I believe I have all my connections right but,my base is tracking zero(0) satellites. The rover however does track satellites…Is there something I might not be doing right?

    kwame-poku replied 5 years, 4 months ago 2 Members · 2 Replies
  • 2 Replies
  • Josh4

    Josh4

    Member
    December 12, 2018 at 10:36 pm

     

    •  make sure the antenna wire is connected properly. If you have another cable swap it out.
    • go into the controller that is connected to the base and make sure that you are tracking at least the GPS constellation. There is a checkbox for this under Sattelite Tracking
  • kwame-poku

    kwame-poku

    Member
    December 12, 2018 at 11:13 pm

    Thanks Josh. I managed to get an antenna(AX1202) and a cable from another crew. I did a setup with this new antenna and it’s tracking the satellites fine.It turns out my AS10 antenna isn’t working.

    Is there something(a Firmware upgrade,etc) that can be done aside replacing the antenna?

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .