Has anyone experienced Trimble survey controller on the Ranger skipping points. For example, starting at 1000 and at point # 1200, it skips to, say 1500, and goes from there? Or starts at 10 and gets to 50 and then skips to 500?
Only when the points already exist in this job and shooting points with the total station, and these numbers were taken before with total station or GPS.
working with Trimble Access for 3 years now, when these points are in a linked file and not yet copied in the current job you get no deltas with the point in the linked file, the point stored is the one you just shot. I think this was different in Trimble Survey Controller, and you always got the deltas compared to the point in the linked file ... but they may have changed this in recent versions.
Chr.
