Carlson centerline

Once again, Carlsonsw shows me just how dumb I am.

Got some old highway plans. Must have been several iterations before the final design, cuz there's quite a few large equalities in the baseline. Trying to use

Centerline>Design Centerline

& input bearings & station values PI to PI. Is it anywhere possible to specify equalities as you go, or must I subtract the value of each equality plus the sum of the preceding equalities from the stations ahead?

With several equalities this could become pretty cumbersome.

Or, Should I just draw the dammed polyline by subtracting station values to derive tangent lengths?

Thanks,

SS