Sorry if I come across a bit harsh and I know it's not my $ but I think for the extremely insane prices they charge, they should treat us a little bet...

Well it will be going back to our supplier for an extremely overpriced repair once we have an extra one available from a coworker doing a 14 day on/of...

I'd love to have the ap but unfortunately it will never happen as my boss switched to all Trimble gear only because we were merging with another compa...

Yeah powersearch was under rated. I didn't realize how important it was until I switched to Trimble. I can use the Leica robot with Trimble access unf...

I honestly haven't had issues with the accuracy, but I'm mindful of the vertical angle and whether I'm using semi active or active for the accuracy I ...

If they were as bad as many seem to think they are (I don't think they are based on my checks over the past couple years) then we might as well use no...

So I guess the theory is they suck bad enough to not bother with the bubble (even though I get within 5mm at worst on distances I tape between what I ...

I've found GNSS more tricky to get working, with radio settings, frequency and baud rate. Even when using all Trimble gear and borrowing someone elses...

I don't know about GNSS but I currently run at Leica tcrp1203+ with access 2022 on a tsc7. I normally use the s5 but if I have to tie in corners refle...

Are DXF's always essentially "linked"? (At least when the job is created with a CSV).

As far as layout random points for clients on the fly, I would get a spanking if I did that. Sometimes clients send foundation plans that don't even c...

If you play around with the snaps. Also think of it this way corner to corner you can Cj that distance. You can create a point at whatever distance al...

I use hot keys all the time. Only thing lately is I'm switching between my DC and the other PC DC and he has a different set of hot keys. I set them u...