Trying to establish a bluetooth-serial connection in order to enter the unit configuration but so far seems impossible. Followed this guide I'm on Wi...

Are you sure? Because i just run it yesterday and left it idle, and after about an hour i went to try and test your steps, it wouldn't even let me add...

So I had a look on the web configuration guide from Trimble website and it shows that you can assign a com port to bleutooth and enter the web ui via ...

Posted by: andrewm I have successfully done this with an R6-4 as a base connected to my SNIP server via serial cable.?ÿ My rover is an R2 and Trimble ...

Posted by: John Hamilton I have setup just such a system with an older R7 GNSS receiver. I output the corrections (RTCM or CMR+) on one of the three s...

I'm pretty sure all frequencies operating on the range used by gps equipment are legal, i'm just a novice on radio communications matters. So what am ...

Hi Nate. So how do you tackle the bleed over whenever you encounter it, and what is the proper frequenct selection procedure? Do you use a scanner for...

Posted by: gschrock therock003, post: 407683, member: 12282 wrote: Weird isnt it that an older R8-3 supports this and R8s does not? I did contact my T...

Posted by: Nate The Surveyor Posted by: therock003 When opting for RTK you stand on a given point for no more than 5 secs and you can instantly take a...

Posted by: Paul in PA OK, I assume you have an RTK base set up but need to get a point?ÿ from somewhere where your base is not talking to the receiver...

I use TBC for normal post-processing scenarios when accuracy is required. Havent practiced PPK before, but i believe time has come that i must learn o...

Well when the tolerance required is not that tight and it concerns a small local area you can get away with RTK. My Question is when RTK is not availa...

So once i set the range on the scanner, and have it listen, what am i expecting to hear in order to notice if the channels are used

I'm a complete newb on matters concerning radio frequencies. So how does a scanner work? When you say it listens on a frequency i mean how do you acco...

UHF. I operate on a pair of Trimble R8- with the external radio antennas. Here is a picture, where there is a large radio tower, and where you can see...