I use the map on FEMA's website to get the panel number for the area that I'm working on. If I get hit with a panel not printed, I back up and use th...

Definitely check out the index map. Unprinted panels may either have no special flood hazard areas or the entire panel may be in one zone. For insta...

I tried the numbers you sent with no luck. I then grabbed my HyperSR as a reference. The Receiver Id is stored on the mainboard and read by PC-CDU o...

If you want to email me the receiver ID# I'll punch it in an tell you what it says.

Are you registered at TopconSupport.com ? I tried to take a look for the firmware but they want a valid Topcon GPS receiver ID#: and they give the fo...

I picked this cap because the price was right, but if I was buying new I'd go with double doors and remove the tailgate.

If it still doesn't work after going through Carlson's setup to get the comm settings correct, then I'd be looking at the cable. With Topcons the cab...

Thanks.I worked out of Jeep Cherokees and Ford Explorers for years and never found a good way to organize them. My normal equipment/stake load is too...

Here's a link to Carlson's SurvCE setup info for your total station. Carlson Knowledge BaseGood Luck.

> I think Bill hit the nail on the head: they are quadrants. > > Are they Hewlett-Packard quadrant notations or trigonometry notations?> ...

All pickup trucks with covers or caps need one of these or equivalent to make the bed accessible without climbing.WebsiteHere's my truck.The cap, roll...

This just begs for a motion activated game camera with night vision. Nothing like photographs of him yanking the corners.

That's the setting I used in AutoCAD 2000 with LDD but I can't find it in AutoCAD 2013. I probably just haven't found the new hiding place yet. I th...

Your interior/exterior settings seem high. Most of my topos have points spaced no more than 50 feet apart so I have mine set to 100-interior 200-exte...

I'd have it draw the t mesh and make sure that it is honoring the 3-d polys. If not, under Triangulate and Contour on the Selection tab make sure tha...

For future reference, if you need to plot a drawing at multiple scales you can set ltscale to 1 and psltscale to 1 then AutoCAD will plot each viewpor...