Last seen: November 18, 2024 9:10 pm
I also discovered a use for the mountain of spent CO2 cartridges that I accumulated.?ÿ They make great rocket bodies until you accidentally reinvent t...
I bought hundreds of those so called M-80's in the mid to late eighties.?ÿ Add a bit of sealant around the base of the cannon fuse and they make great...
I once drove an hour and half to re-stake a celltower and guy wires (20 minutes of fieldwork max).?ÿ Realized while setting up that the prism and pole...
pdfattach should work in intellicad
That comment pertained to TDD.
Short for "Utility"?
Several national banks around here will not cash a check drawn on their bank for you if you do not have any account with them. Some banks also b...
You were learning how to spot possible danger in the field.?ÿ File it under safety program expense.?ÿ?ÿ
When I use the circular object routine reflectorless, I put the vertical crosshair on the left edge, take a reading, then put the crosshair on t...
As a child sodas were a rare treat and sweets were pretty uncommon as well.?ÿ By my early teens lawn mowing provided the revenue, freedom and mobility...
I learned along time ago........stake your backsight.?ÿ Even if you're on A backsighting B rather than B backsighting A, the elevation difference will...
Assuming that your HI was correct, a 3d translate from B to A in step one above should fix the horizontal and vertical.
If you know the range of points collected from the bad setup, you can fix it with a simple translate/rotate.?ÿ CREATE A COPY OF THE FILE BEFORE YOU DO...
I just got a base & rover set of R10-2's. They are phenomenal in full canopy and the internal batteries are lasting close to six hours on th...
Even the old Topcon 3b's and 303's that I started with emitted a red light from the gun in low light conditions.?ÿ I've always thought that since the ...
Put a nut on top and the threads won't get mangled.
Set up a style for the network rover that specifies the serial number for the unit you typically use for your base.?ÿ Run your 3 minute session on the...
Apparently VRS users were fine but using single base resulted in not getting corrections.
I can't tell a story in an entertaining fashion.... but I can beat computers and CAD software into submission. ????
I believe the file was AutoCAD2018 file format and I have sent back dgn v8 and AutoCAD 2000 versions.?ÿ Let me know if the results make sense. ?ÿ
