I've used both and would take the simple Seco jig over the True-Plumb in a heartbeat. I found that unless you have a block or concrete wall in a prote...

My little science projectExcellent work, thank you for posting your results. I have two 4000sse's and one 4000ssi and I know that all are of the age w...

I loaded 8.2.1 on Friday and ran a couple of quick checks on a job site. Version 8.2.1 of TopSurv does still store 3pts per corner for all corners exc...

Thanks StephenSorry, I read your original post, but I had forgotten that you had the readme file already. I have 2 4000sse's and 1 4000ssi, but so far...

Here's a link to UNAVCO's page where they have a zip file of version 7.19b of the firmware. Inside that zip file is a readme file that gives a good ho...

Jim Frame has gone through this in the last few months and can probably give you good advice if he's not awol for the holidays. Check out these two th...

See this thread [msg]113009[/msg]

I posted several bugs/issues back in the spring and early summer. Mostly they just ignored my posts. I got fed up with the lack of response from Topc...

I don't know. I don't think I've used the vertical offset routine since I loaded 8.2 in October. I will likely load 8.2.1 and run it through a few tes...

Thanks TC, I'll check it out. I really just wanted to put the info out there so someone else doesn't have to spend a morning trying to figure out why ...