You could use LDD 2006, but why? If you have C3D, you also have access to LDD 2009. The LDD part didn't change between 2006 and 2009, but the core A...
> The learning curve is minimal, not near what I went through going from LDD r14 straight to LDD 2007.Less of a learning curve...? Really? There ...
I always thought it was pretty ironic how we use "duct tape" for a huge variety of things, but it isn't that great for ventilation ducts (it works wel...
So, if they fail to prepare and there's a lot of damage, they're incompetent. If they prepare and there's not a lot of damage, they "drank the Kool-A...
You can see the wipeout frames by typingWIPEOUT F ONJust keep in mind that the frames will show up on prints if they are on, so before printing, you'l...
> I went cold turkey through my bank. The swipe machine ran about $125 and Amex takes about $7/month, Visa/MC $10 each and Discover, Nada. They a...
Autodesk has had this value default to 1000 for years and years now. They should probably change it.In fact, given the speed of today's computers, I ...
Autocad has a nasty tendency to create a lot of temp files, and leave them hanging around. Too many, and you can start having problems, even if there...
Yep, you should only wear pants when they're waisted.
> And other than the fact that it "looks really cool", why?I thought they were "lookin' like a fool with your pants on the ground..." 😉
We pretty much just use the Survey Database process the F2F commands and generate linework. From that point on, we work only in the drawing. Editing...
If that command did nothing, then you're probably trying to adjust Survey Points. These are "special" Cogo Points that were created from a Survey Dat...
I was presuming the OP wants an elevation adjustment, not horizontal. My earlier comment only applies to an elevation adjustment. You wouldn't want ...
What are you trying to change?Most things respond to the MOVE command. You can run into exceptions, though, if you're using the Survey Database.
I think I see their problem.....> Looks like a Metric Conversion error> > from link:> > Now the rover is less than 31 feet (50 meters) ...
Doug - FCC's reason for approving LightSquared is thatFor a President who seems stymied at every turn, that guy sure is responsible for a lot... It's...
I'm glad people find it useful!Unfortunately, the AU people failed to record my presentation. I have some improvements I want to make to those Powerp...
Here's a link to the PowerPoint presentation I created when I presented this topic at Autodesk University:And here's a link to the paper I wrote a few...
defpointsAutodesk recommends that you avoid using the Defpoints layer.Starting some time ago (R14...?) you can make any layer "non plotting".The Defpo...
DIMALIGNEDYou don't need to type anything in the Text Override in order to change the precision. You can just change that in the Properties (although...
