@robots ?ÿ when trying to do collimation calibration I get error that its to big for software to correct. I can see with my bare eye that its not ho...

Anyone know how to mechanically adjust VA angle on 5600 ? Mine is a bit off so it wont do the software collimation calibration.

@robots ok, fixed it now. Turns out PyCharm works but not IDLE IDE, running in windows 10. Managed to backup both my 5602 and 600 ATS. Thank you so ...

I am having problems reading out my 5602 , see pic. Any suggestions ? ?ÿ ?ÿ

@bugg you could use a lab power supply to feed the circuit while switching cells

@robots did you figure out how to reset the counter too ? ?ÿ

Do you still need the firmware ? ?ÿ