-
Zenith 25 issues
I??m hoping someone here could help me out.
I have a zenith 25(geo max) unit. We have been using it for the past couple years with little to no problems.
We are currently working two jobs, and I have operated this unit on both sites with no issues. Today I went back to the previous job, which I haven??t been on in a little over a week. Keep in mind the geo max was operating fine yesterday. Well this morning I went to set everything up. My base loaded up fine, and then I proceeded to load my rover up after.
Every time I try to monitor and skyplot, with my rover, it freezes within the first 30 percent or so and drops all satellites and connection to the base.
To make sure I wasn??t having a base issue I ran monitor skyplot with it and it was showing me Autonomous at 100%, which is good. Everything looked right on that end.
Just to check and see if the rover was truly jacked up I took my unit over to the other job site and it loaded right up. My rover was speaking to my base and I was 100% fixed. This job site is about 3 miles away.
I feel like it has to be some kind of interference, but I??m not a 100% sure.
Any tips? Thanks
-
2 Replies
-
Local interference sounds like the most logical culprit.
-
That was it. Spoke to a representative that guided me along. Someone near me was using the same data transfer. I just had to change the mode. Thanks
Log in to reply.