Trimble "Communications Error" message
This just started happening a few days ago. Trimble Access, R10-2, TDC600
Start the VRS survey, connects to the VRS, pick the mount point, then after about 10 seconds it says “Communications Error” and stops. Usually I can repeat and it is OK, sometimes it does it twice or more in a row. Doesn’t always happen, actually infrequently
I am wondering…is this
1) VRS problem?
2) receiver problem”
3) TDC600 problem?
4) internet problem?
5) bluetooth problem?
I wish the error message was a bit more informative.
I saw this a few times in the past, but a lot more this past week.
- This discussion was modified 3 months, 2 weeks ago by john-hamilton.
Log in to reply.