Intellicad 10 – Arc command
I’ve run across an issue in Carlson 2021 (Intellicad 10) where arcs are drawn incorrectly. I often run in plats or deeds using chord bearings, then go back and draw in the arcs using the arc command (start, end, radius method). If dynamic input is enabled (where you key in input at the cursor rather than on the command line) the arc command will take the radius dynamically from your cursor position rather than using the number you key in. Setting DYNMODE to (0) will cause it accept your radius keyed in at the command line rather than grabbing a random radius based on your cursor position. I’ve submitted the issue to Carlson.
Log in to reply.